alexn
10 µW
Hi, this is my first post. I have installed a 500W 48V drive on a Talon3. Still on original 3.7 firmware. Many typical issues as I've read on many posts such as full battery showing on VCLD5 as a single bar with no assist, intermittent pulsing, assistance underwhelming. Remaking cable connections, ensuring battery was fully seated on holder, and the magnet was a good distance from sensor helped these issues, but...
All is going well, mostly, until I coast for a few seconds, maybe to slow for a few seconds to avoid a lorry on a narrow road for instance, then when I pedal again there's nothing. And it doesn't come back until I power off, stop, place my feed on ground, restart, then there's full assist again.
Any suggestions to avoid having to keep restarting?
All is going well, mostly, until I coast for a few seconds, maybe to slow for a few seconds to avoid a lorry on a narrow road for instance, then when I pedal again there's nothing. And it doesn't come back until I power off, stop, place my feed on ground, restart, then there's full assist again.
Any suggestions to avoid having to keep restarting?