I have an EZEE geared hub motor kit from ebikes.ca which uses the CA3 and a thun torque sensor.I recently purchased the 24 pole mini PAS sensor from grin to add to the kit to compare torque sensing to cadence sensing, having both mounted on the BB and using separate presets
in the CA3 to switch back and forth.My question is,is there a good way to connect both sensors into the single PAS wire on the CA3 so I can conveniently switch back and forth without having to unplug and plug each sensor in the wiring bundle. could you build a Y adaptor for the input wires and route one wire from each thru an AB switch? or is there a way to switch it internally in the CA3?
in the CA3 to switch back and forth.My question is,is there a good way to connect both sensors into the single PAS wire on the CA3 so I can conveniently switch back and forth without having to unplug and plug each sensor in the wiring bundle. could you build a Y adaptor for the input wires and route one wire from each thru an AB switch? or is there a way to switch it internally in the CA3?