So I just received my Flipsky 75100 and I'm trying to set it up to run my sensorless Heinzmann PMS080 middrive.
I downloaded Vesc_Tool3.1 and connected via USB cable.
It wanted a firmware update before it would do anything else so now it's running 5.3 and calling itself 75_300_R2.
I configured the throttle input and ran the "Setup motors FOC". It spun the motor as it did its thing and declared it was successful. However when I try my throttle it just kinda grunts the motor over a few degrees at a time.
What have I missed?
I downloaded Vesc_Tool3.1 and connected via USB cable.
It wanted a firmware update before it would do anything else so now it's running 5.3 and calling itself 75_300_R2.
I configured the throttle input and ran the "Setup motors FOC". It spun the motor as it did its thing and declared it was successful. However when I try my throttle it just kinda grunts the motor over a few degrees at a time.
What have I missed?