Hi all, I shouldn't really be concerned about this as the lcd eats up ~1w at maximum, but I noticed that my voltage display turns on even when I power the scooter off(using the switch in the display.)
I was very confused, so I just took a multimeter and read the voltage in between the power wire and ground on my ESC, and sure enough, I was reading the battery voltage. Is there any way to stop the LCD from powering on when the ESC is turned off?
(For reference, the motors don't spin.)
I'm just worried as the LCD display can go down below 60V and still function, meaning if I leave the bike on it may discharge below rechargeable level, and brick the 1000$ battery pack.
Thanks!
I was very confused, so I just took a multimeter and read the voltage in between the power wire and ground on my ESC, and sure enough, I was reading the battery voltage. Is there any way to stop the LCD from powering on when the ESC is turned off?
(For reference, the motors don't spin.)
I'm just worried as the LCD display can go down below 60V and still function, meaning if I leave the bike on it may discharge below rechargeable level, and brick the 1000$ battery pack.
Thanks!