diggler
1 kW
Good stuff.
Thanks for the tip.
Thanks for the tip.
Damn man, just saw this thread and I already did what you mentioned today already.madin88 said:make sure the sealing ring does not chafe against the wire. i have removed the stock lock ring (very sharp and big risk of short circuit!!) and used a zip tie instead
diggler said:just got done test riding! Woo! This thing is fast!
But I thought for sure I'd be able to go 50mph, I only got it up to 42. :lol:
That's fast enough for me.
That's 64.1 batt amps 119.8 phase amps. 18s lipo charged to 4.1v per cell. On 120% throttle
So yah it was that last hall.
I had to chip away at it with the flat head, sucker was really glued in good.
phase wires are 12 awg then 10awg once they get outside the axle.
What's the highest battery amps I can set the 18fet 4110 Infineon to?
Also what is the max phase amps do you think I should go?
Doctorbass said:diggler said:just got done test riding! Woo! This thing is fast!
But I thought for sure I'd be able to go 50mph, I only got it up to 42. :lol:
That's fast enough for me.
That's 64.1 batt amps 119.8 phase amps. 18s lipo charged to 4.1v per cell. On 120% throttle
So yah it was that last hall.
I had to chip away at it with the flat head, sucker was really glued in good.
phase wires are 12 awg then 10awg once they get outside the axle.
What's the highest battery amps I can set the 18fet 4110 Infineon to?
Also what is the max phase amps do you think I should go?
Highest batt amp i have used on my 18 fets 4110 was 100A and 250A phase with max speed set to 99% ( not 100% because this is to avoid mosfet blow)
above 40mph what will limit your speed if you have the right motor turn is the batt amp.
Doc
Doc