ridethelightning said:i dug around some and found the 23 pole info somewhere.... that what i was doing wrong,using the 46,not23. (but i used wheel circumference in mm),and now im getting believable speedo.
i believe i have a 10k thermistor already installed in my cromotor from methods. perhaps i can just wire that straight into the max-e pin? although i dont know if it compatable.
You are right, circumference is in mm and not cm. NTC 10k thermistor is supported by latest firmware.
Today i was at home and the weather was nice, so i went out for a short ride (to test acceleration etc.). it was short because i had a crash.
during accelerating i was looking to the display. with the eyes back to the street i see i was riding towards the road bank with a big puddle.
No more chance to pull around because to much speed (60kmh+). I fell to the right and bike and i chafe over the asphalt. I hurt my top lip and my arm..
The wound on my arm is almost not worth to mention, but my lip is swollen big. I would say it could have beed more worse and i had luck.
until now i
- always wear a helmet
- never look to the display anymore while driving fast