hugh21
1 mW
I built a delta trike, 2wd. Pedal power runs the left rear wheel via a jackshaft. The right is a Magic Pie 2 direct drive 1000 watt. Golden Motor CA sold me the CA version 3.14 along with the Grin 12 pole 2 wire sensor disc. The salesperson said the CA and disc were needed to have a working PAS. However I cannot get the PAS to work. The throttle works. I set the PAS exactly as the supplied booklet said and watched a video by Justin to confirm the right steps were followed. With the Magic Pie I was told to cut the green throttle wire on the handlebar, and cut the green throttle wire going into the analyst, then splice the 2 together.
Then run a wire from the supplied Grin shunt to splice the green wire from the shunt to the other end of the cut throttle green wire. In effect running the throttle wire into the analyst and the other side down to the shunt. The other side of the shunt has a supplied connector that plugs into the analyst. Hoping maybe some one here might have experienced this and be able to offer some tips.
Golden Motor CA does not want to talk to me in person, insisting on using a ticket system where I email them about the problem and they reply usually a day later. They are trying to help but its slow and we are coming up on a couple weeks with zero progress
Then run a wire from the supplied Grin shunt to splice the green wire from the shunt to the other end of the cut throttle green wire. In effect running the throttle wire into the analyst and the other side down to the shunt. The other side of the shunt has a supplied connector that plugs into the analyst. Hoping maybe some one here might have experienced this and be able to offer some tips.
Golden Motor CA does not want to talk to me in person, insisting on using a ticket system where I email them about the problem and they reply usually a day later. They are trying to help but its slow and we are coming up on a couple weeks with zero progress