Recent content by Ham549

Had this problem turns out that the three wires to the motor were hooked up wrong.

Still no word, and now the phone number takes me to Go mobility Scooters who say I have the wrong company. Research shows that Jeff Cooperman runs both a2b and Go Mobility Check out the two websites http://www.gomobilityscooters.com and http://a2bscooters.com note they both list the same phone...

They haven't said anything and the statious of my order on there tracking page remains blank.

I have ordered a Lashout bike rack from a2b scooters http://store.a2bscooters.com/ ten days ago and after numeriouse attempts to call them (always goes streight to voice mail) and e-mail them. I have not heard anything and have been unable to get a hold of anybody. I am starting to get very...

Well I lack the know how to split a ping battery and unfortunately for me everyone who does know how is probably in San Fransisco (I'm in Massachusetts). Also the rack cost over $50 and I was quoted almost as much to weld it back together as it would cost for a new rack. The bike rides fine even...

So I just got my hub motor set up to elivate all the problems I had with the old side mounted motor when something else came up. My bike rack has finely had it and the welds have failed in many places. Well my set up was this a marine battery case with bubble wrap, and other soft things to...

I upgraded my bike to a hub-motor and have noticed a sigfentely higher wattage draw than my old set up. This new set up I have seen draw up to 1,900 Watts and I am worried that might be to much for my battery. I have a Ping 48V 20AH V2.5 LiFePO4 Battery Pack and it says recommended for motors of...

Thanks for all your help I swaped the wires in the way Linn sujusted it still diden't work. I could have made a mistake in wire matching since one strand of wires was black and I had to trace them back to the plug each time to match color. Any way I just happened to switch two hall wires and it...

Uh no it does not work fine.

Hooked up and under powered more problems see the video I posted here http://www.youtube.com/watch?v=hpclZZwXrUk Specs Crystalyte Motor Style:HT3525 - torque motor (REAR) 12 FET 3077 Mark II Extreme Modder LYEN Edition Controller Rev4 torque arm Ping 48v 20AH LiFePO battery Phase wiring...

I never liked bullett conectors because they weren't as secure as other connectors, but if they are better maybe I should. It is hard for me to tell the wireing color comming from the motor though because it is all covered up.

My controller is a 12 FET 3077 Mark II Extreme Modder LYEN Edition Controller I just got the motor and here are my hook ups A 5 pin hook up of some sort for the hall sensor (and I have no idea what wire corresponds to what) And a three pronged plug for the power. Does anyone know where to get...

To keep the cables from torching I cut one shorter then the other. So if I had a battery one lead would be 4 inches long with .5 inch of conductor exposed and the other will be eight inches with .5 inches of conductor exposed so in order for them to touch you would physically bend the longer...

I think can rearrange the three power wires until I have the right combination, but doing so on the hall sensor will be difficult. How will I know which wire goes where on the hall sensor pickup?

BUMP Because I know someone on here must have a HS3540.