I used a hall throttle earlier, but now I have changed to a domino:
I had some clearence issue with my regen thumb throttle, for now I just removed it.
I can´t use it with this controller anyway.
I had a problem with throttle runaway once, or what it is called in english?
Well, I had full throttle and a power wheele. I got close to a well, and eased on the throttle to fend off. But nothing happened
I crashed..
The groove leading up to the well is me.. The stick on the well was standing up before.
Actually, all the grooves are mine :wink:
It turned out to probably not be an issue with the throttle primarily, but interference in the 5v line from the temp sensor in the motor at high phase currents.
I also have a problem with high motor temp. But the motor does`nt really get hot..
I can get 160degrees c in the windings, but the shell is only about 40degrees c.
I thought it is time for some statoraid:
I drilled a 3mm hole, I used a tube on the drillbit to not go to deep. I did´nt take the motor apart.
I drilled close to the chainsprocket.
As i remember from the statoraid thread, I should just add until I get higher amps whith the wheel in the air. And it should take a little more than 5ml probably.
Well, I added 5ml, no difference. I added 2 more, still no difference.
I took the bike out for a spin, still got up to 160degrees c rather easy, and still about 40 degrees on the shell.
Now I have added the remaining 3ml, still no difference in frewheel amps..
I guess I will see if it makes any difference when I ride it.