Hello,
I'm building my 14S6P pack with VT6A that I plan to use on my upgraded Coast Cycle Buzzraw with BBSHD and ASI855.
I'm using 0.15 pure nickel strip 10mm at 8ms pulse. The weld is very solid. I went to 12ms on the serial connections.
I consider Side 1 finished and I'm almost done with completing the serial connections by adding some additional strips (on side 2)
Then I'll wire the BMS (Neptune 15) and discharge wires and finish the pack with some kapton. I also plan to add desoldering bread on the positive and negative areas.
Any opinions on the pack so far?
Side 1
Side 2
Thanks !
I'm building my 14S6P pack with VT6A that I plan to use on my upgraded Coast Cycle Buzzraw with BBSHD and ASI855.
I'm using 0.15 pure nickel strip 10mm at 8ms pulse. The weld is very solid. I went to 12ms on the serial connections.
I consider Side 1 finished and I'm almost done with completing the serial connections by adding some additional strips (on side 2)
Then I'll wire the BMS (Neptune 15) and discharge wires and finish the pack with some kapton. I also plan to add desoldering bread on the positive and negative areas.
Any opinions on the pack so far?
Side 1
Side 2
Thanks !