Hello. hall effect throttles usually give about 1-4 volts. Some motor controllers were programmed to start at closed throttle and with pot throttles it is 0 volts.
I do not know of any way to reprogram the controller and wanted to replace a pot thumb throttle with a hall effect one. is there a simple an easy way to set hall throttle to zero without any additional buttons or switches? Adding a resistor may do the trick but then it will lower the voltage at the fully open throttle as well. or is it easier to buy a pot twist throttle like magura... (or any other suggestions for under $50 ?)
My motor and a controller is from TidalForce m-750x
thank you for any help.
I do not know of any way to reprogram the controller and wanted to replace a pot thumb throttle with a hall effect one. is there a simple an easy way to set hall throttle to zero without any additional buttons or switches? Adding a resistor may do the trick but then it will lower the voltage at the fully open throttle as well. or is it easier to buy a pot twist throttle like magura... (or any other suggestions for under $50 ?)
My motor and a controller is from TidalForce m-750x
thank you for any help.