I have a Sabvoton 72150 and an Evolution moped hub motor with no information except 3kw, 72v, 60 phase angle.
I bought a usb cable and a bluetooth dongle for the Sabvoton.
I hooked up to both quite easily. I used the dongle and Mqcon app to run 36 phase wire tests, and the closest I got to a rotating wheel, was a slow creep for about 20 degrees before the usual 'hall error'.
I usually used 10 or 15 amps as the test current. I did try 30 amps a couple of times but it made no difference.
It says offset angle is 54 degrees. this never changes.
Haven't noticed anywhere to change the phase angle.
I don't know what ' motor parameter' means. It stays on 300.
Is it possible my new controller is a bad one?
I simple can't find any combination that does any more than twitch the wheel, either forward or backward a few degrees before stopping with hall error. Quite loudly sometimes. Occasionally it seems to just jam. I would expect all these scenarios at some point in the process, but also one or two that actually turn the wheel, but the controller just stops after each twitch and shows me 13 green lights. The app shows hall fault.
I switch the controller off and back on and either move the wheel to try again or try a different combination.
I have the white (temperature?) wire in the phase block, grounded with 1k ohm resister as the motor doesn't appear to have a temp sensor.
The motor is fine and works beautifully when I re-instate the old controller, but it's restricted, so it has to go.
Going mad now! been weeks of fiddling and nothing
I bought a usb cable and a bluetooth dongle for the Sabvoton.
I hooked up to both quite easily. I used the dongle and Mqcon app to run 36 phase wire tests, and the closest I got to a rotating wheel, was a slow creep for about 20 degrees before the usual 'hall error'.
I usually used 10 or 15 amps as the test current. I did try 30 amps a couple of times but it made no difference.
It says offset angle is 54 degrees. this never changes.
Haven't noticed anywhere to change the phase angle.
I don't know what ' motor parameter' means. It stays on 300.
Is it possible my new controller is a bad one?
I simple can't find any combination that does any more than twitch the wheel, either forward or backward a few degrees before stopping with hall error. Quite loudly sometimes. Occasionally it seems to just jam. I would expect all these scenarios at some point in the process, but also one or two that actually turn the wheel, but the controller just stops after each twitch and shows me 13 green lights. The app shows hall fault.
I switch the controller off and back on and either move the wheel to try again or try a different combination.
I have the white (temperature?) wire in the phase block, grounded with 1k ohm resister as the motor doesn't appear to have a temp sensor.
The motor is fine and works beautifully when I re-instate the old controller, but it's restricted, so it has to go.
Going mad now! been weeks of fiddling and nothing