Sabvoton controller and Boma motor setup

[Pota]

Has someone connected these two components together.

Im having a hard time getting it to "Hall angle test: ok"

I dont know if its my hall angle which is wrong, hall wire or phase wires, but it just dont want to go past "Test fail 4 or test fail 3"

My current is set to 15, my angle is set to 0, 60, 120, 180 and 240. Still no luck.

 

[Yermommy]

Hey man, did you ever figure this out? I’m stuck on the same errors.

Update: I was programming a mxus 3k turbo but I'm sure the process is similar for other motors. I did a factory restore from the settings then ran the angle test a few more times. I kept failing but it eventually worked. Really not sure how I did it, but it may have something to do with keeping the wheel as level as possible, meaning don't tilt it one side or the other since I believe this interferes with the angle matching program.