Alan B
100 GW
On my setup it required both a switched signal and the variable signal. The switched signal did cut off the power (the throttle would not produce power), then the variable signal controlled the amount of braking (in addition to the settings in the controller).
Here is the wiring diagram and software (from page 2 of this thread). The throttle connector is 4 pin and contains two analog input wires instead of one. My controller came from zombiess:
https://endless-sphere.com/forums/viewtopic.php?f=4&t=62240&start=25#p931253
Here is the wiring diagram and software (from page 2 of this thread). The throttle connector is 4 pin and contains two analog input wires instead of one. My controller came from zombiess:
https://endless-sphere.com/forums/viewtopic.php?f=4&t=62240&start=25#p931253