Hummina Shadeeba
1 MW
The plate with the hole is too tight as intended. Filing it down to just fit sucks and will use the other version as it allows me to glue the part into the frame and then bang in the motor for an interference fit. See if that works first.
https://imgur.com/a/in7HXnv
One day be done these but I screwed up again and now have 700$ of silicone molds I won’t use as well as the same amount in machined abs the molds were made from. The chainring hit the clamp part and had to mirror image all parts to get the clamp on the non-drive side.
I’ve got two of these giant abs parts now that are trash or decorations. Luckily machined parts aren’t too expensive and think it’s was like 150$ w shipping
https://imgur.com/a/0CcuEMP
This will be a block of resin n fiberglass with the cells imbedded. The challenge being to make it strong enough to not crack or deform from being too soft and need repeated tightening of the clamp plate.
https://imgur.com/a/in7HXnv
One day be done these but I screwed up again and now have 700$ of silicone molds I won’t use as well as the same amount in machined abs the molds were made from. The chainring hit the clamp part and had to mirror image all parts to get the clamp on the non-drive side.
I’ve got two of these giant abs parts now that are trash or decorations. Luckily machined parts aren’t too expensive and think it’s was like 150$ w shipping
https://imgur.com/a/0CcuEMP
This will be a block of resin n fiberglass with the cells imbedded. The challenge being to make it strong enough to not crack or deform from being too soft and need repeated tightening of the clamp plate.