Eastwood said:
So I received my mxus 3K along with all the other parts for this wheel build. I have a question about using these copper washers. Basically when I’m using the washer the angle of the spoke it’s not coming out at 90° from the hub, or even remotely straight. When I don’t use the washer the spoke comes out of the flange at 90°. I’m not sure if I should use a different washer or maybe no washer. I was able to bend the washer inside the oversize flange holes to help with the spoke angle but it’s still coming out way too far which would cause me to bend the spokes a lot just to get it to line up to the wheel Here’s a few pictures
Also I’m using 13 DT Swiss copper washers
Get a close up pic of the seating surfaces im not sure but the bend on your spoke may be to early not long enough from bend to spoke head.
The flange thickness is wider than a standard bike hub i think that may be throwing the spoke out of alignment. If the spokes are meant for a standard wheel that is, off top off my head im sure i used about 6mm to bend