Hello all,
I was wondering if anyone has any experience with using open source firmware with the cyclone 3k mid-drive?
I have on order a cyclone 3k with the tiny sinewave controller (all they had in stock). Is there any open source firmware someone could point me to I could use on that? Or even a different controller that I could get and install some open source firmware into?
I am looking to have full control over my motor without the cost of high end controllers. I have pretty good access to electrical tools as needed, so I'm not afraid of a project.
I'm planning to take an older full suspension mountain bike I purchased recently and turn it into a trials motorcycle/bicycle hybrid with the cyclone.
I was wondering if anyone has any experience with using open source firmware with the cyclone 3k mid-drive?
I have on order a cyclone 3k with the tiny sinewave controller (all they had in stock). Is there any open source firmware someone could point me to I could use on that? Or even a different controller that I could get and install some open source firmware into?
I am looking to have full control over my motor without the cost of high end controllers. I have pretty good access to electrical tools as needed, so I'm not afraid of a project.
I'm planning to take an older full suspension mountain bike I purchased recently and turn it into a trials motorcycle/bicycle hybrid with the cyclone.