Ian
100 W
I am Running 12S lipo on a em3ev Mac with infineon controller, CA V3, and would like to know if I can smooth out the throttle a little bit more. I was thinking of geting a grin phaserunner but they are out of stock until next summer. I use the CA auto cruise feature quite a lot and might fit a basic PAS onto the bike to avoid throttle use also.
Basic operation is ok, but it is still a bit twitchy and there is some mild oscillation at some speeds when on auto cruise. Has anyone with similar setup fine-tuned the Cycle Analyst throttle settings to as good as it can be? I am looking through some of the CA advanced settings and am not sure which are relevant and which not; and I don't want to get into counter productive tinkering.
Shunt value: checked and correct
Control Mode: pass-thru. Is there a recommended "closed loop" throttle mode that might be better ? Choices are current, power, and speed.
Throttle Uprate: I have reduced the value here with good results, it has definitely helped with a smoother progression of power from a stop.
Thanks for any advice
Ian
Basic operation is ok, but it is still a bit twitchy and there is some mild oscillation at some speeds when on auto cruise. Has anyone with similar setup fine-tuned the Cycle Analyst throttle settings to as good as it can be? I am looking through some of the CA advanced settings and am not sure which are relevant and which not; and I don't want to get into counter productive tinkering.
Shunt value: checked and correct
Control Mode: pass-thru. Is there a recommended "closed loop" throttle mode that might be better ? Choices are current, power, and speed.
Throttle Uprate: I have reduced the value here with good results, it has definitely helped with a smoother progression of power from a stop.
Thanks for any advice
Ian