Hello.
I'n sorry if this has been answered already.
I have a very old CA3-DPS from 2015, with goldenmotor controler, with the integrated speed sensor.
It had an unrecognized version by the CAsStup utility.
It was something like r1b16 (I didn't put too much attention to it).
When I updated to the latest firwmare (3.14) I realised that the CA didn't report any speed anymore.
The wheel circumference is correctly setup.
I tried with older firmware like the CA3-1b13, and I could get sporadic speed report at 1/10th the real speed, with very laggy display (took a few seconds to show 4-5km/h).
Do I have to setup something special for the DPS? I couldnt find any settings relative to the speed senror in the utility.
I can hear the sensor "clicking" when the magnet pass in front of it, I'm pretty sure the sensor is still working.
I'n sorry if this has been answered already.
I have a very old CA3-DPS from 2015, with goldenmotor controler, with the integrated speed sensor.
It had an unrecognized version by the CAsStup utility.
It was something like r1b16 (I didn't put too much attention to it).
When I updated to the latest firwmare (3.14) I realised that the CA didn't report any speed anymore.
The wheel circumference is correctly setup.
I tried with older firmware like the CA3-1b13, and I could get sporadic speed report at 1/10th the real speed, with very laggy display (took a few seconds to show 4-5km/h).
Do I have to setup something special for the DPS? I couldnt find any settings relative to the speed senror in the utility.
I can hear the sensor "clicking" when the magnet pass in front of it, I'm pretty sure the sensor is still working.