Hi,
I have installed on my bike Magic Pie 3 motor with Magic Controller V2. After around 5000 km I have problem with throttle, or better says it works only without connected Hall sensors. So I tried all possible checks. Hall sensors they seems to be ok. Why? I disassembled motor and check firstly wires. I tried to twitch with them during measurements if there is some bad connection, but all have same resistance all time. Then I check all sensors with magnet. All switch between 0 and 5 Volts. Just one (yellow one) switch to 4,65 V, but in service told me that it is ok. I check also all sequence and it is ok. From the shop, where I bought motor and controller they send me another controller and it behave equally.
So I connect Hall sensor connector again to the controller and it works, nice, smoothly I was very happy. But after may be 10 km, the throttle stopped working again. So I had to, disconnect hall sensors for way back home. At home I just tried without any adjustments connect hall sensors again to the controller and it start to work, but again just for may be 1 kilometer and then it stop working again. When it stop working and I push the throttle the motor just several times starts jerkily, but then there is no response. So I am using my bike without connected Hall sensors because it is my transport vehicle. But I have no idea, where should be problem. I tried also several times reset the controller, but nothing happened. Sorry for my English, hopefully you understand my problem.
I have installed on my bike Magic Pie 3 motor with Magic Controller V2. After around 5000 km I have problem with throttle, or better says it works only without connected Hall sensors. So I tried all possible checks. Hall sensors they seems to be ok. Why? I disassembled motor and check firstly wires. I tried to twitch with them during measurements if there is some bad connection, but all have same resistance all time. Then I check all sensors with magnet. All switch between 0 and 5 Volts. Just one (yellow one) switch to 4,65 V, but in service told me that it is ok. I check also all sequence and it is ok. From the shop, where I bought motor and controller they send me another controller and it behave equally.
So I connect Hall sensor connector again to the controller and it works, nice, smoothly I was very happy. But after may be 10 km, the throttle stopped working again. So I had to, disconnect hall sensors for way back home. At home I just tried without any adjustments connect hall sensors again to the controller and it start to work, but again just for may be 1 kilometer and then it stop working again. When it stop working and I push the throttle the motor just several times starts jerkily, but then there is no response. So I am using my bike without connected Hall sensors because it is my transport vehicle. But I have no idea, where should be problem. I tried also several times reset the controller, but nothing happened. Sorry for my English, hopefully you understand my problem.