Hi Guys. I have a 52 volt battery and a 48 volt motor. I'm struggling to get the Open Firmware to work, and would like to revert back to the original firmware to see if the motor will run on that with the original screen. I never tried the motor before flashing the open firmware, ( because of the mismatch of voltages), so the fault could be in there.
Question, has anybody tried a step down voltage controller like this one to do the job? Or does anyone know of any better solutions?
https://www.ebay.co.uk/itm/202866188159
Many thanks
Question, has anybody tried a step down voltage controller like this one to do the job? Or does anyone know of any better solutions?
https://www.ebay.co.uk/itm/202866188159
Many thanks