docw009 said:
If you bought the KT controllers, with an LCD5, you probably can turn the current by 50% with one of the C parameters in the LCD setup. Set C5=3. See your display manual. It does work. I was getting 140W in level 1 with a 25A controller. I trimmed it down to 100W.
I was going to point out that the 9 pin connector on the first controller will probably need am extension. looks pretty short, unless you mount the controller on the front fender.
I have two of these motors coming. Gotta find some beater bikes A nice 3 speed hub bike from the 70''s would work. I have plenty of 36V 12A controllers,
Good info, thanks, I am not sure when I will get the controllers, yes, I did order 1 LCD5 and 1 LED890 controller,
I should have ordered additional torque arms but in the rush I forgot :-(.
I received my wheels yesterday, holi mother of peanuts,
Chalo, thanks, cubic yards of the [edit] bio degradable stuff here.
3 wheels - 2 with shorter 9 pin wire and 1 with long wire, 1 with the schwable tire and 2 with no marking tires. tires had air in em, woa.
I turned the spindle by hand and it was NOT that free turning in all of them, so there would be some rolling resistance?
PSW Power order - any clue how long it take to mosey over? 4 weeks? I did not create an account and there seems to be no way to track my order [edit] I tried the order status page and says my order # is not valid.
Battery - I bought a bunch of the scooters batteries, I finally received the connector from Jehu and I did a quick capacity test and very happy with results, nearly 11 ah till BMS cut off, [max charge to 40v only]