jodiug said:CiDi said:To configure the Bafang M500 / M600 motor without using the BESST programmer, you can use this interface.
Link interface USB to CAN on Amazon:
https://www.amazon.co.uk/USB-Converter-Module-Raspberry-Zero/dp/B07Q812QK8/ref=sr_1_2?dchild=1&keywords=usb+to+can+innomaker&qid=1604409709&sr=8-2
Link cables Bafang HMI M500/M600 on e-bike-technologies:
https://www.e-bike-technologies.de/index.php/en/connectors/connectors-signal/connectors-higo-mini-f-series/higo-b5-f-detail
https://www.e-bike-technologies.de/index.php/en/connectors/connectors-signal/connectors-higo-mini-f-series/higo-s5-f-detail
Below are the software and the instructions for configuration and use.
I have this CAN analyzer: https://www.antratek.nl/usb-can-analyzer
After wiring the white/green/black cable I connected it to my bike and turned on the battery. I installed the driver on my PC. The InnoMaker software is not showing any Device Index, so I might have to order the other USB interface. Should the device index show up automatically when the USB is plugged in and the bike is turned on?
You need to use your device's software and it should work.
Search here:
https://github.com/SeeedDocument/USB-CAN-Analyzer/tree/master/res/V7.20
Let me know if it works.
It could be better than the innomaker interface.