steveo
100 kW
Hey Everyone,
I picked up this motor from goldenmotor.ca website.. it is their top of the line inrunner motor..
specs on site...
Model: HPM-10KW -- High Power BLDC Motor
Voltage:48V/72V/96V/120V
Rated Power:8KW-20KW
Efficeincy: 91%
Phase Resistance (Milliohm): 3.1/48V; 6.0/72V; 18.0/120V
Phase Induction(100KHZ): 34uH/48V; 77uH/72V; 252uH/120v
Speed: 2000-6000rpm (customizable)
Weight:17Kgs Casing: Aluminium
Length (height): 170mm Diameter: 206mm
things to point out IMO...
-dual Coils
-dual sets of hall sensors
-temp sensor i think as well.. not 100%
-has a massive 1" shaft..
-rpm range of 3000-6000
-will run between 48v - 120v
-weight about 37lbs
-water cooled; no venting holes in the water cooled motor..
i'll be using this for my outboard boat motor project..
....
I'll post some video eventually...
I've done some testing.. this motor is a beast.. freewheeling near top rpm on my infinion controller - 18fet..4110---100v it pulls between 12-15amps constant doesn't that seem abnormally high?... the cogging on this motor is pertty harsh... indicating lots of torque.. so i hope
-steveo
I picked up this motor from goldenmotor.ca website.. it is their top of the line inrunner motor..
specs on site...
Model: HPM-10KW -- High Power BLDC Motor
Voltage:48V/72V/96V/120V
Rated Power:8KW-20KW
Efficeincy: 91%
Phase Resistance (Milliohm): 3.1/48V; 6.0/72V; 18.0/120V
Phase Induction(100KHZ): 34uH/48V; 77uH/72V; 252uH/120v
Speed: 2000-6000rpm (customizable)
Weight:17Kgs Casing: Aluminium
Length (height): 170mm Diameter: 206mm
things to point out IMO...
-dual Coils
-dual sets of hall sensors
-temp sensor i think as well.. not 100%
-has a massive 1" shaft..
-rpm range of 3000-6000
-will run between 48v - 120v
-weight about 37lbs
-water cooled; no venting holes in the water cooled motor..
i'll be using this for my outboard boat motor project..
....
I'll post some video eventually...
I've done some testing.. this motor is a beast.. freewheeling near top rpm on my infinion controller - 18fet..4110---100v it pulls between 12-15amps constant doesn't that seem abnormally high?... the cogging on this motor is pertty harsh... indicating lots of torque.. so i hope
-steveo