Hello All. I picked up one of these cheap Voilamart (ZCRiding) "1500W" to try building an ebike with. Apparently you can flip from 750W to 1500W through the display. The problem is the wiring. It uses waterproof connectors and the power wires are pretty small. I think 14AWG from the battery to the internal controller. The wires from my battery are 10AWG ,much more inline with the 35A internal controller it's supposed to have. But I'm suspecting something is off. I haven't split the hub yet but I was planning to beef up the power wires to at least 12AWG but there isn't a lot of room coming out of this hub. I haven't found much online about this particular model but I'm thinking 1500W with an internal controller is a bit overrated "As is". I went with a 52V battery because this seemed to be the upper limit of what this controller would do. Any suggestions would be appreciated.