silentguy
100 W
- Joined
- Sep 15, 2009
- Messages
- 162
I’m still not clear on the wiring of X4 and the white torque sensor wire from the Sempu T4
I wire the white sensor from the Sempu T4 to X4 ?
I wire the White, Red, Black wires from the thumb throttle to the controller throttle connector ?
Sorry for all the questions.
Here’s the English translation from the German forum . :
Here it is described how a torque sensor can be connected. General information on torque sensors can be found here: Torque sensors for pedelecs
The torque sensor typically provides a pulsed speed signal like a PAS and an analog torque signal like a thumb throttle. The connection is correspondingly simple. If you want to operate a thumb gas parallel to the torque sensor, the torque signal must be connected to connection X4, see Chapter 2 at the bottom. The torque sensors usually require their own power supply, which can be provided from the battery voltage via a DC / DC converter.
Here is an example of an E-Rider T9 sensor
I wire the white sensor from the Sempu T4 to X4 ?
I wire the White, Red, Black wires from the thumb throttle to the controller throttle connector ?
Sorry for all the questions.
Here’s the English translation from the German forum . :
Here it is described how a torque sensor can be connected. General information on torque sensors can be found here: Torque sensors for pedelecs
The torque sensor typically provides a pulsed speed signal like a PAS and an analog torque signal like a thumb throttle. The connection is correspondingly simple. If you want to operate a thumb gas parallel to the torque sensor, the torque signal must be connected to connection X4, see Chapter 2 at the bottom. The torque sensors usually require their own power supply, which can be provided from the battery voltage via a DC / DC converter.
Here is an example of an E-Rider T9 sensor