So I finally got around to flashing my controller and display with the latest firmware.
After flashing, resetting to defaults and loading back my config, I also did a couple of auto tunes on the motor.
Now the motor runs really rough when starting. If I roll on the throttle slowly it will smooth out, but if I pin the throttle fast it will jerk violently before stalling and stopping.
It seems like it's having trouble with the initial square wave part of turning the motor. I tried turning off square wave boost, adjusting boost current, played with acceleration limits and nothing seems to help.
Any advise on what I can play with to smooth out the initial acceleration and stop it stalling?
Cheers
After flashing, resetting to defaults and loading back my config, I also did a couple of auto tunes on the motor.
Now the motor runs really rough when starting. If I roll on the throttle slowly it will smooth out, but if I pin the throttle fast it will jerk violently before stalling and stopping.
It seems like it's having trouble with the initial square wave part of turning the motor. I tried turning off square wave boost, adjusting boost current, played with acceleration limits and nothing seems to help.
Any advise on what I can play with to smooth out the initial acceleration and stop it stalling?
Cheers